PR 234304 FCF line profile requires datum, not required per standard

huangyhg

FCF line profile requires datum, not required per standard
<< Steven George  --  07/31/05  00:51:53>>
In PC-DMIS, the FCF Line Profile dimension requires a datum, which is incorrect.  Per the standard, datums may be used for this dimension, but are not necessary when evaluating the profile shape taken at a cross section.  I encountered this while testing the ability to produce a line-profile dimension of a circle.
<<END>>

<< Steven George  --  01/28/06  20:11:20>>
Verified fixed with the 1.22.06 build of v4.0rc.
<<END>>
<< Changes made by Steven George -- 01/28/06  20:11:25>>
Status:  RESOLVED to CLOSED
<<END>>
<< Changes made by Steven George -- 01/11/06  14:34:20>>
Action:  Paola Pallo to Steven George, Status:  CLOSED to RESOLVED
<<END>>
<< Paola Pallo  --  12/07/05  17:25:27>>
Reviewed.
<<END>>
<< Changes made by Paola Pallo -- 12/07/05  17:23:54>>
Status:  REVIEW to CLOSED
<<END>>
<< Don Turcotte  --  11/07/05  14:05:33>>
This has been fixed by PR232870 && 235252.  Form only allows line and surface profile without datums.  Form and location requires datums.
<<END>>
<< Changes made by Don Turcotte -- 11/07/05  14:05:41>>
Action:  Don Turcotte to Paola Pallo, Status:  OPEN to REVIEW
<<END>>
<< Changes made by Tim Wernicke -- 08/01/05  08:46:38>>
Priority:  to High
<<END>>