looking for a threaded inser

huangyhg

looking for a threaded insert.
5/16-18" thread. .750 deep.
brass or steel.
looking for ms/nas/mil/an.  hopefully someone has insert p/n's memorized?
sw2008 office pro sp4.0
intel core 2 duo cpu
2.2ghz, 2.00gb ram
quadrofx 3700
spacepilot
check out our whitepaper library.
uglay... ok
helical coil? nahhhh maybe not... they typically come in 0.5xd multiples of the base diameter [1, 1.5, 2, 2.5, 3d]
note: your depth suggests a solid-wall insert: light-weight [thin-wall], heavy-weight [thick wall], with coarse or fine outer threads???
regards, wil taylor
try nas1832-5-750
close but is .3125-28unjf
  
wes c.
------------------------------
no trees were killed in the sending of this message, but a large number of electrons were terribly inconvenienced.
i assumed sandwich insert
wes c.
------------------------------
no trees were killed in the sending of this message, but a large number of electrons were terribly inconvenienced.
wktaylor:
solid-wall insert: heavy-weight [thick wall], with coarse inner threads, no outer threads (press-fit installation)
sw2008 office pro sp4.0
intel core 2 duo cpu
2.2ghz, 2.00gb ram
quadrofx 3700
spacepilot
i have spec'd helicoil for now.  this insert is going to be in a handle (which will be tightened and loosened) repeatedly so i am leaning towards a solid body, thick wall insert.
sw2008 office pro sp4.0
intel core 2 duo cpu
2.2ghz, 2.00gb ram
quadrofx 3700
spacepilot
btw, the 0.750" deep is just an estimate.  if there is a 1" deep insert or .600 deep i think it would be fine.  i just need it to be 5/16-18 interior thread.
sw2008 office pro sp4.0
intel core 2 duo cpu
2.2ghz, 2.00gb ram
quadrofx 3700
spacepilot