filling an existing cmu wall

huangyhg

filling an existing cmu wall
i have an existing hollow cmu foundation wall with a substantial point load bearing on it.  i want to fill the cores of the wall solid at these locations, but it's in a crawlspace, and there are many locations.  i am aware of injecting on concrete to repair cracks, but is there anything similar to this that will fill in the cores solid without damaging the existing cmu's?
thanks
find a job or post a job opening
can you get access to the wall?
yon can remove a face shell at locations to be filled..
yes, you can access it through a crawl space.  the contractor was trying to avoid installing temp posting in the finished 1st floor while he broke open the blocks.  i was looking to find some sort of epoxy that could be pumped in a couple of 1"-2" holes in each core.
why can't you use a "pea gravel" (3/8" stone) mix and pump it into the cores through a 2" diameter hole with a standard grout pump?  
for cmu foundation frost walls, is it normally required to fill all cells below grade with grout in a cold climate?
sorry, i meant my post to be a new thread. please ignore this post!