Could you create a test part program (>= V42) for me?

huangyhg

Could you create a test part program (>= V42) for me?
Yanhua,

I have attached a V42R test program.  When the datum is a set of cylinders, this is not working (FCFLAGE1 is the composite true position on the datum set, FCFLAGE2 is the true position that uses the datum set).  When the datum is a single cylinder, this does work correctly (FCFLAGE3 is the composite true position on the datum, FCFLAGE4 is the true position that uses the datum).  So there still are some problems here.   I also tried this in V42 beta and V43B with the same problems (does not work when the datum is a set of cylinders).



Regards,

Don

From: Yanhua HUANG
Sent: Monday, August 18, 2008 5:30 AM
To: Don Turcotte
Subject: Could you create a test part program (>= V42) for me?



Don,

Question about PR 246135 - Using tp from datum to refine datum virtual condition, use lower segment of datum composite tp value.

Could you create a test part program (>= V42) for me? The test part program was not attached with the PR. I do not know how to walk into your changed code for the PR when testing.

yanhua