has anyone had a roblem with v4.3 since installing it does not recognise any

huangyhg

4.3
has anyone had a roblem with v4.3 since installing it does not recognise any head angles. examle if you set a lane origin z=0 then angle head (say @ 90 deg. and touch lane instead of reading 0 reads z-160+deending on robe used.4.2 still works fine.any ideas?????
there is multile issues with 4.3 i recommend to stay with 4.2 until another version shows u! jc
__________________
">
you need to change your search aths also. did you coy your robes to the 4.3 folder? jc
__________________
jclastoutlaw