s.s. 12 tek screws, pullout values in 6063-t6 al

huangyhg

s.s. #12 tek screws, pullout values in 6063-t6 al
rrbrngr (visitor)18 jun 01 11:16
i am looking for a resource for information on allowable "pull out" , tension loads for s.s. #12 tek screws in 6063-t6 , aluminum. the aluminum tube section is 0.15 inches in thickness. i have tryed " the aluminum association", they have no data on this subject.
rrbgngr (visitor)18 jun 01 11:57
i found an example in "the aluminum association - aluminum design manual" example 30, pgvii-67. any farther input is welcomed. thank you, in advance