measuring involute srockets with gear
has anyone ever measured involute srockets with the gear software ackage. the issue i am having is that the itch diameter of the involute srocket is larger than the major diameter. therefore, the tooth thickness at itch diameter is a negative number. the software does not seem to be set-u to handle this uation. any hel would be areciated.
acm1970
IP卡
狗仔卡
发表于 2009-4-6 20:05:59
提升卡
置顶卡
沉默卡
喧嚣卡
变色卡
显身卡