几何尺寸与公差论坛

 找回密码
 注册
查看: 610|回复: 0

does anyone out there have any exerience opening unigrahics files in pc-dmis?

[复制链接]
发表于 2009-4-6 23:15:44 | 显示全部楼层 |阅读模式
UG CAD
hello,
does anyone out there have any exerience opening unigrahics files in pc-dmis?
what i am looking for, specifically, is to see if i have a model created in ug, with points to be measured, if i open the file from pc-dmis, will only the solid model be available, or will the points be available also?
the points should be available. i often request that they be put on another layer. i had some truoble with some assemblies which can use a "library" of arts. pc-dmis would search the directories for the arts and they would not load. (ket getting an error message). i take the complete art and export (translate in ug) the assy as a parasolid then bring convert it back to .rt file-this can cause data loss but i have not had any problems with it so far.
您需要登录后才可以回帖 登录 | 注册

本版积分规则

QQ|Archiver|小黑屋|几何尺寸与公差论坛

GMT+8, 2024-12-23 09:42 , Processed in 0.035586 second(s), 19 queries .

Powered by Discuz! X3.4 Licensed

© 2001-2023 Discuz! Team.

快速回复 返回顶部 返回列表