【转帖】feature tree

yang686526

feature tree
this is perhaps a strange question, but i shall ask it nonetheless.
it is possible to add something to the "feature" tree which is not a feature?
we, like most companies i suspect, have a good deal of mirrored parts. with the mirrored part you can see from the feature tree the original handed part as it were; you cannot from the original part see that a mirror has already been created.
it would be nice to be able to add something obvious, where the user can readily see it (ie the feature tree) something which indicates that a mirror of that part exists.
slightly out of the box idea but would welcome ideas suggestions how other people deal with this.
thanks
not totally obvious, but you could add a comment to a part in the tree that states such. rmb/comment/add comment the problem is that you have to look to see if there is a comment - it's not obvious.
wt
you could just create dummy sketch or plane and rename it to something obvious like mirrored part exists. keep it in the same place in the feature tree.
don
rmb->tree display->show feature description. set the description as mirror exists
hi sir,
may i know how can i rename a line segment using api programming .
regards,
aqeel ahmed
aqeel.ahmed@vvi.cc
quick