|
|
macro feature
just curious but is there anyone out there using this? by this i mean macro features.
and i am looking for a center of mass macro that will self update. i used to have a copy of this but no longer. anybody out there have this? basically it will create sketch + point and set to cog, then upon any rebuild reposition the point if required.
the one i had only worked on a part, and i am not sure if possible with assemblies but would be nice to cover both. yeah i know there are some improvements in 2009 but we are stuck with 2008 for right now.
--matt |
|
IP卡
狗仔卡
发表于 2009-4-12 21:35:53
提升卡
置顶卡
沉默卡
喧嚣卡
变色卡
显身卡