【转帖】configuration linear pattern

yang686526

configuration / linear pattern
i have a rectangle block where i am putting in six holes.  i used the linear pattern to add the six holes.  now i want to make a three hole version exactly half the size.  is it possible to specify the configuration on which patterned holes to suppress?  i am using sw2008.
check out our whitepaper library.
double-click the pattern in the task pane (do not right-click and edit feature).  after double-clicking the pattern, double-click the quantity number and pick "this configuration".  
now each pattern will have independent quantities.
alas, i don't have a design library to reference to so i can't go this route.  i see what you are saying though.
quote:
alas, i don't have a design library to reference to so i can't go this route.
would you explain that statement, please?
i'm not sure where you're getting "design library" from.  unless possibly from flores' reference to the "task pane."  i believe he meant "feature manager design tree."
-handleman, cswp (the new, easy test)
yeah that is what i thought he meant. and when i looked in one of my books i saw that the only option he seemed to be suggesting was that of a "design library".
so right now i have
1. a sketch of the rectangle which is extruded
2. a sketch of the hole which is the linear pattern.
in the feature manager design tree (fmdt) i see sketch but not the pattern. i double click on the sketch but it only opens it for editing.  i then can right click on one of the circles and see "pattern0".  to make life easier, i have uploaded this simple-yet-doing-my-head in part.

ok, the problem is that you used a sketch pattern rather than a feature pattern.  make your sketch so that it contains only one hole and use a feature pattern to create the rest.
-handleman, cswp (the new, easy test)
thanks guys, once again a sldprt was worth more than a few posts.
oops, wrong terminology but some of you knew what i meant.