|
|
hole wizard end conditions!
is it possible to use hole wizard and create a tapped hole, without having the tip of the drill appear in the model? i just want the hole to be flat when i do a blind tapped hole, i don't want to see the tip of the drill in my model or drawing.
thanks,
eng-tips forums is member supported.
you can adjust the drill angle to 180? (flat), and the depth of thread in the hw options. |
|
IP卡
狗仔卡
发表于 2009-4-13 11:47:38
提升卡
置顶卡
沉默卡
喧嚣卡
变色卡
显身卡