几何尺寸与公差论坛

 找回密码
 注册
查看: 1086|回复: 0

【转帖】flatness call ou

[复制链接]
发表于 2009-4-29 19:57:54 | 显示全部楼层 |阅读模式
flatness call out
i am working with a vendor who wants to spec out the folowing :
1,5 mm/2 m flatness
1,5 mm/2 m straightness
i think calling out flatness and striaghtness this way is wrong . any ideas?
-mechantaeus
quote:
work hard and work smart
check out our whitepaper library.
normally invoked as a slope refinement specified as a second callout. this is a common way to control the waviness within the total tolerance control which must have an equal or bigger envelope. useful if the part can stand to be warped but not rippled.
is ok.
but use "-", not "/". can be mis-read.
chris
sr. mechanical designer, cad
solidworks 05 sp0.1 / pdmworks 05
is y14.5 applicable to the drawing?
the flatness and straightness specification is being applied on a "per unit" basis.  the flatness and straightness can vary 1,5mm over any 2m area.  the concept is illustrated in asme y14.5m-1994, paragraph 6.4.1.1.4 for straightness and 6.4.2.1.1 for flatness.  the "/" between the values is correct.  also, there is usually an overall specification applied with a "per unit" specification to prevent significant accummulation of tolerances over the total length and width of the part.  this effect is illustrated in asme y14.5-1994, figure 6-5.
if these two specifications are being applied to the same surface, there is no need to have both.  since they are both of the same value, the straightness specification (2d tolerance) will already be controlled as part of the flatness specification (3d tolerance).  the straightness specification would only only be useful if it refined the straightness to something better than 1,5mm/2m.
gdtguy
gdtguy,
thanks for another clear explanation!  it deserves a star.
...y14.5 is applicable to all drawings.
chris
sr. mechanical designer, cad
solidworks 05 sp0.1 / pdmworks 05
ctopher,
  y14.5 is only applicable if stated on the drawing.  gd&t has been used on drawings before there even was a y14.5 standard.  that is why it is important that the standard and year of release be noted.
i agree, but it should be stated on all dwgs. which usually isn't followed anyway.
chris
sr. mechanical designer, cad
solidworks 05 sp0.1 / pdmworks 05
there seems to be some confusion with regards to the use of y14.5.  according to what i read, it must be noted on the drawing or some other  document referenced on that particular drawing.  it is not to be assumed applicable.
thank you all , i think i have a better understanding now, each one of you deserves a star.
-mechantaeus
quote:
work hard and work smart
您需要登录后才可以回帖 登录 | 注册

本版积分规则

QQ|Archiver|小黑屋|几何尺寸与公差论坛

GMT+8, 2024-12-23 02:40 , Processed in 0.036629 second(s), 20 queries .

Powered by Discuz! X3.4 Licensed

© 2001-2023 Discuz! Team.

快速回复 返回顶部 返回列表