|
|
number of points required for cmm measurement
is there any north american standard that specify how many points are required to measure a feature using cmm machine. i heard the britis standard bs7172 specifies this requirement for example 9 points for a surface 15 points for a cylinder.
find a job or post a job opening
while i'm sure that there are many qualified followers of this forum who can answer your qustion, it may be better suited here:
qc, inspection & testing engineering forum
i don't think it's quite what you're asking for but is asme b89 ( |
|
IP卡
狗仔卡
发表于 2009-4-29 21:02:01
提升卡
置顶卡
沉默卡
喧嚣卡
变色卡
显身卡