|
|
significant figures
should you apply the law of significant figures to gd&t?
cmwatson78 in what respect?
asme y14.5m-1994 (assuming that's the standard you work to) talks about leading & trailing 0s in section 2.3. it differs for metric and inch systems.
kenat, probably the least qualified checker you'll ever meet...
also, in engineering, rounding is always to the even number to account for accumulation.
"wildfires are dangerous, hard to control, and economically catastrophic."
ben loosli |
|
IP卡
狗仔卡
发表于 2009-4-29 21:58:47
提升卡
置顶卡
沉默卡
喧嚣卡
变色卡
显身卡