ansi 9standards0 code issues - amse pictorial drawing

huangyhg

ansi amse pictorial drawing
hello everyone,
in asme y14.4m-1989 "pictorial drawings" i need to know what the standard is for assembly layouts. my question is if i show an exploded front isometric view on 1/2 of sheet1 and a reverse isometric view on the other half, do i need to use a view line to show how i derived the view? i guess what i am asking is do we have to follow asme y13.3m-1994 convention on assembly/critical feature drawings?
thanks.
matt b.
as far as i know, i think if you write "isometric" below the views, you will be fine.
fyi, you should be following asme y14.4m-1994
ctopher,
   my standard says asme y14.5m-1994, am i missing something?
bradley
i apologize, i miss-read. i thought i was looking at asme y14.5m-1989. you are right. that's what happens when i read too fast.