ansi 9standards0 code issues - ansi 150 jis 10k

huangyhg

ansi ansi  150 & jis 10k
dear professionals,
can anyone please advise what are the differences between ansi 150 & jis10k end stds? i currently have a valve manufactured to ansi 150 & i wish to know if any modifications need to be made for it to conform to jis10k.
i'd be grateful if anyone can advise me on where to obtain further reference on the matter.
kind regards,
jerri
jerri, ansi  150 is a pressure rating.
asme b16.5, b16.10 and b16.34 are the respective specs.
compared to these jis 10k are:
od - larger with some exceptions
rf - larger
pcd - larger or same
rf height - larger
flange thickness - n/a
drilling - larger or same
bolt holes - larger
f2f - same
therfore to fit an ansi  150 within a jis space you will need to check the number of bolt holes(as there are a few anomilies)relevant to size to ensure they match, then elongate the bolt holes radially outwards on the ansi  valve to match the new pcd.
good luck
b
thank you for the information.
they are very useful to me.
kind regards,
jerri