cmu ultrasonic testing

huangyhg

cmu ultrasonic testing
i am looking for information concerning the ultrasonic (or otherwise) testing of cmu walls to check for rebar and if the cells have been grout or concrete filled other than using a masonry drill bit and a flash light.  i have seen the handheld devices that will locate the rebar and measure concrete cover, but are these the same devices that check for filled cells of the cmu?
thanks in advance.
check out our whitepaper library.
check out thermographic evaluation of the cmu wall also.  here's a link to an article i found on google
thank you ucfse. as always, most helpful. just what we are looking for.
i have also found that a ferroscan will work--probably the same handheld device you are referring to.
ground pentrating radar (gpr) will be best.
ultrasonic testing will not locate rebar, but it can locate voids - by trained users using the "direct transission" method.
there was a structural engineer mag article a while back on cmu walls with gpr that i will try and dig out for you.
hth
structural engineer magazine feb 2005, "seeing is believing" which is about surface penetrating radar for condition assessment of concrete masonry structures, by blaise a. blabac, p.e.
thanks ingenuity, i have that issue.  
if any one wants to see the article online go to:
here is another article by gerald a. dalrymple, p.e. entitled "how can you be sure?"
it mentions gpr and also infra-red imaging for cmu grouting verification.