cold formed steel section properties

huangyhg

cold formed steel section properties
i need to analyze a metal building for a beam load of a cable tray on a cee 10x3.5x12gage and was looking for something that listed the section properties.  this is a lipped channel made from 12 gage sheet steel.  is there somewhere that properties are listed or should i just calculate them myself?  if i ignore the lip and assume the corner is sharp, will this be conservative?
tia
check out our whitepaper library.
i believe that the "cee" designation is from dale/incor which can be found here:
see is this is a standard section listed in the ssma literature.
is = if...  is there a way to edit your previous posts??