PR 250501 Create a wrong third reference ID (CENTER TO CENTER) when create

huangyhg

Create  a wrong  third reference ID (CENTER TO CENTER) when create 2D distance dimension in V4.2B and V4.3B.
<< Yanhua Huang  --  09/26/07  16:27:24>>
Create  a wrong  third reference ID (CENTER TO CENTER) when create 2D distance dimension in V4.2B and V4.3B.
Steps to reproduce:
1) create a new part program in V4.2B
2) Create two Auto Points
3) Create a distance dimension
Results:
DIM DIST1= 2D DISTANCE FROM POINT PNT1 TO POINT PNT2     (CENTER TO CENTER),NO_RADIUS  UNITS=MM,$
GRAPH=OFF  TEXT=OFF  MULT=10.00  OUTPUT=BOTH
AX    NOMINAL       +TOL       -TOL       MEAS        DEV     OUTTOL
M       0.000      0.010      0.010      0.000      0.000      0.000 ----#----

Expected Results:
I don't think (CENTER TO CENTER) is a reference ID, 3.
<<END>>

<< Yanhua Huang  --  10/28/08  15:51:18>>
Tested in PCDIMS V44B. Closed.
<<END>>
<< Changes made by Yanhua Huang -- 10/28/08  15:51:24>>
Status:  MOREINFO to CLOSED
<<END>>
<< System Administrator  --  2008/10/23  17:35:30>>
PLEASE VERIFY THAT THIS IS AN ISSUE IN PC-DMIS 4.4 AUDIT VERSION.  IF SO, PLEASE RESET THE STATUS TO OPEN.  OTHERWISE PLEASE CLOSE.
<<END>>
<< Changes made by System Administrator  --  2008/10/23  17:35:30>>
Status:  OPEN to MOREINFO
<<END>>
<< Changes made by Neil Kay -- 08/29/08  09:58:49>>
Action:  Woody Anderson to Yanhua Huang, Assigned:  Woody Anderson to Yanhua Huang
<<END>>
<< Yanhua Huang  --  09/26/07  17:05:47>>
I set priority Critical, because the problem troubles change managemnt in V4.2B.
Yanhua
<<END>>