performing work for an architec

huangyhg

performing work for an architect
let me bounce this question off of you guys to see what you all have been doing.
i have been asked by an architect to size some footings for a project in a state which i am not currently registered.  the structure is a low hazard structure which does not require an engineer's seal, only an architects.  if i were licensed in the state i would not think twice about doing the work but even though i would not be sealing the work i am uncertain about this kind of arrangement.
how are the architects normally doing this work when an engineer is not required?  are they just pulling sizes off some standard charts and calling it good?  in a way i am glad that this architect is seeking the help of a structural engineer and i know him indirectly through a common friend so i would like to help him out.
i look forward to hearing your thoughts.
thanks
i would double check on the requirement for engineering license participation vs. an architect-adequate situation.  some states do allow architects to perform the engineering tasks on certain smaller structures - but i'd personally make sure.
if that is the case, then providing the architect with engineering services is not a problem in my book.  you are technically not "practicing engineering" without a license since the definition of engineering practice usually includes a reference to the types of structures that require a license.
so legally ok.  ethically - that's up to you but i don't see any issue ethically either.
that seems resonable to me.  i have double checked with the state and they did confirm that only an architects stamp is required for this structure.  i suppose i could give a second call to the state and try to talk to someone a little higher since it is possible i was just talking to a secretary or an assistant.
thanks for the quick feedback!
it's hard to say without reading the state rules- and that might not help, even (which state, by the way?)
suppose i manufacture widgits.  design of these is exempt due to their being a manufactured product.  but the way i understand most of the engineering laws, if i retain you as an engineering consultant to design those widgits, you're still practicing engineering whether the product needs a pe seal or not.
the state is illinois.
i am an se in illinois (i think jae is, as well).  i believe the rules state that an architect can perform structural engineering work, and an se can perform architectural work.
anyway, this architect is doing you a favor--he is taking the liability for your work.
daveatkins
i am not registerted in illinois, but when i contacted the illinois registration board a few years ago about the same type of situation, they told me that the architect absolutely could not do structural engineering.  i would contact them, if i were you.
any danger of someone coming after you the engineer that helps the architect out in this way if the architect messes up?
if i understand the term 'sealed drawing', doesn't apply here--because the engineer is not registered to practice in that particular state, then the engineer cannot 'seal' the drawing, right? personally i would be concerned with my professional liability, since i am 'practicing without a license.' it seems odd that it is ok for non registered engineers to be doing what looks to me to be within the scope of a registered engineer's job. who decides what is 'simple enough' or 'smalle enough' for an architect to sign off? if the whole point of the professional registration laws is to 'protect public safety' then who decides when the public safety is endangered or when it isn't?
in my opinion, if you design the footing you are providing engineering services whether or not you provide sealed and signed documents.  most states require the engineer to be licensed in the state before they are legally allowed to provide engineering services.  i am working on licensure in new jersey.  as i understand their laws, you can provide engineering services if the length of the project is less than 30 days, no sealed documents are required, and you are licensed in another state.  otherwise, you have to be licensed in nj to practice engineering in that state.  there is no law like that in oklahoma.  however, perhaps illinois has a law similar to nj.
i find a "design manual" online here: