slotted hole close to edge
i have a situation where a oversized hole needs to be slotted to fit the anchor rod. would you just weld on extra plate to keep the min. edge distance? what do you guys think?
you could check the remaining steel for shear capacity and compare it to the load in the direction of the slot.
a minimum edge distance is not required for anchor rods not subjected to shear.
IP卡
狗仔卡
发表于 2009-9-15 23:47:58
提升卡
置顶卡
沉默卡
喧嚣卡
变色卡
显身卡