几何尺寸与公差论坛

 找回密码
 注册
查看: 472|回复: 0

vehicle barriers

[复制链接]
发表于 2009-9-16 18:09:13 | 显示全部楼层 |阅读模式
vehicle barriers
a project i am working on includes a few guard shacks that are protected from vehicle collision by cantilevered cast-in-place concrete walls.  the design criteria for the barrier walls is to be aashto roadside design guide 3.  as a building engineer, i do not have this reference.  can someone summarize the design loads for me?
the basic collision load for aashto vehicles is 10 kips applied at the top of the barrier height (for most cases about 3' above roadway).  there are several distribution diagrams in the official aashto design guide, but for bridge design of the safety barrier curb we use the 10 kip load.  that load is then chased through the barrier and into the bridge slab - it sometimes controls the slab design.
regards,
qshake
eng-tips forums:real solutions for real problems really quick.
just a reminder that the 10 kip load is distributed over a 5' width (2 kips/ft.)
您需要登录后才可以回帖 登录 | 注册

本版积分规则

QQ|Archiver|小黑屋|几何尺寸与公差论坛

GMT+8, 2025-1-11 00:12 , Processed in 0.039412 second(s), 20 queries .

Powered by Discuz! X3.4 Licensed

© 2001-2023 Discuz! Team.

快速回复 返回顶部 返回列表