【转帖】changing dimensions

yang686526

changing dimensions
ok, i'm banging my head against a wall here..
all i want to do is run a macro that will change dimensions d1 and d2
d1 + 1 degree
d2 - .0061111 inches
i have to do this for 360 degrees so having a keyboard shortcut that will do this will make my day just that more shorter..
i tried recording a macro to get the code, but that didn't work out too well.. and the api help is a bit greek to me as far as the full syntax of the macro/program..
thx for any help you can offer
sw2009 sp3.0
pentium d 840-3.2 ghz
4gb ddr2 667
ati firegl v5600 - driver ver. 8.440.0.0
winxp pro 32bit
an understanding that without any understanding, we would all be misunderstood..
tom,
simply add two euations :
d1 = d1 + 1 degree
&
d2 = d2 - .0061111 inches
now just rebuild and you are done. you can set a macro for doing the rebuild and assign a short cut key to it.
deepak gupta
sw2007 sp5.0
sw2009 sp2.1
ahhhhhh thx.. i knew it had to be easy..
not sure if its a bug, but it worked out great, i had to follow a line that was moved by the above dimensions, and create a point on the endpoint of the line.. after every point creation, the dims would adjust..
sw2009 sp3.0
pentium d 840-3.2 ghz
4gb ddr2 667
ati firegl v5600 - driver ver. 8.440.0.0
winxp pro 32bit
an understanding that without any understanding, we would all be misunderstood..
quick