Can tolerances be adjusted via Call ModelDoc.SetTessationQuality?

yogy

Q:
Dear Robin,
Can tolerances be adjusted via Call ModelDoc.SetTessationQuality?
Need I call ModelDoc.Rebuild after call SetTessationQuality?
Code as follows:
swModelDoc.SetTessellationQuality (tessellationQualityNum); swModelDoc.Rebuild (rebuildOptions);
Yogy

yogy

R:
Dear,
You should be able to get finer tessellation using SetTessellationQuality.  Use ModelDoc2::GraphicsRedraw2 after using this method to update part.
Regards,
Robin Richter
SolidWorks Technical Support