几何尺寸与公差论坛

 找回密码
 注册
查看: 1778|回复: 0

uns thread information

[复制链接]
发表于 2009-9-6 09:37:22 | 显示全部楼层 |阅读模式
uns thread information
hi,
trying to find some thread data (i.e. maj. dia, pitch dia. etc...etc..) for the following thread:
1.563 - 18 uns - 3a
the machinist's handbook outlines some unified thread types but does not seem to include this uns thread! unless i am looking in the wrong place! any help would be appreciated
thanks
check out our whitepaper library.
johni357,
my copy of machinery's handbook lists uns threads as "selected combinations" of diameter and pitch.  uns threads are listed in table 14 labeled "standard series and selected combinations".  the catch is that the 1.563-18 thread is listed as unef (extra fine) not uns.  the good news is the table gives you all the data you need for the 1-9/16-18 thread.
timelord
you could search in google, or this forum:
timelordfff">, i think you meant table 4.
"art without engineering is dreaming; engineering without art is calculating."
mm,
my bad, table 4 is correct. in the section called screw thread systems.
timelord
in uns the s means special, so by definition it is not a standard size and is unlikely to be in a pre-calculated table.  this means you should calculate it from scratch using the definitions in asme b1.1 or equivalent.
from what timelord says your example may not actually be a special but a standard unef.
您需要登录后才可以回帖 登录 | 注册

本版积分规则

QQ|Archiver|小黑屋|几何尺寸与公差论坛

GMT+8, 2024-3-29 17:44 , Processed in 0.034166 second(s), 19 queries .

Powered by Discuz! X3.4 Licensed

© 2001-2023 Discuz! Team.

快速回复 返回顶部 返回列表