【转帖】fastener hole tolerance

yang686526

fastener hole tolerance
hi,
i'm in the aircraft/aerospace business and was wondering if anyone knows of an online card/printout that gives the fastener hole size for various fit types (transition fit, shifted transition, etc).
thanks much,
dan
eng-tips forums is member supported.
are you asking for 'specialty' aerospace fasteners (like those causing trouble with the 787 etc. or for general fasteners (screws, rivets etc)?  for specialty fasteners i'd look at the vendor/distributer website.
the standard fit tables are usually for shaft/hole combinations, not explicitly for fasteners