【转帖】hexagonal callout on drawing

yang686526

hexagonal callout on drawing
hello all -
first time post... i need to call out a hexagonal shaft on a drawing, but i'm not sure if there is a specific way to call it out (i.e. flat to flat, 脴 of hex, etc.)
any and all help is appreciated.
best regards,
victor
mechanical engineer/consultant
medical devices
"when i am working on a problem, i do not think of beauty, but when i've finished, if the solution is not beautiful, i know it is wrong."
- r. buckminster fuller
usually, you place dimensions on both  "across flats" and "across corners" since dimensional variation means you cannot have a perfect hexagonal form ( inradius:circumradius ratio of √3:2).
regards,
cory
if it is not a tolerance critical part, i only dimension across the flats and add "hex" after the dimension.  a reference dimension across corners is good for stk ref.
for a tolerance critical part i think i've usually seen 3x dimension across flats and 6x 60掳.
i've also seen dimension across flats with hex after it like ewh.
rarely if ever have i seen it dimensioned to the corners or the equivalent diameter.
interestingly i don't see a single example of a hex or other regular polygon in asme y14.5m, i only looked briefly though.
kenat, probably the least qualified checker you'll ever meet...
the most common hexagons are for fasteners.  page 39-41 of the following document shows dimensions for across flats and across corners.
mil-dtl-1222j studs, bolts, screws and nuts for applications where a high degree of reliability is required; general specification for
available at assist: