PR #253044 construction a slot from two circles make pc-dmis crash

huangyhg

construction a slot from two circles make pc-dmis crash
<< Jean Wang  --  02/01/08  23:28:19>>
I measured two circles  and construct the  round slot with them,then execute the part program,pc-dmis crash during the execution. The file is construction.rar on the server.
<<END>>

huangyhg

<< Dan Zwick  --  02/04/08  16:49:04>>
Well, I tried this today and I got neither a crash nor a weird slot. I did have some trouble with the simulator trying to execute the entire part program (it stopped sending data after the first circle), but I don't think that is related. If I executed up to and including the first circle and then executed the rest it worked fine. The circles are good and the slot is also good.

Could you try this again with the latest RC? Perhaps something has changed.
<<END>>

<< Changes made by Dan Zwick -- 02/04/08  16:49:48>>
Action:  Dan Zwick to Jean Wang, Status:  OPEN to RESOLVED
<<END>>

<< Dan Zwick  --  02/01/08  17:30:55>>
I tried this in simulate online mode with the data in the debug file. I didn't get a crash in 4..2R in the debugger, so I tried running the release configuration of pcdlrn.exe. It didn't crash either, but it did produce a really weird slot (see attached file). This data seems strange, though. A lot of of the points aren't even on the part. Did you calibrate the probe and align the part before measuring? If not, could you try it again?
<<END>>

<< Dan Zwick  --  02/01/08  16:23:24>>
Well, it certainly didn't crash in 4.3R. I'll try it in 4.2R.
<<END>>

<< Changes made by Tim Wernicke -- 02/01/08  16:00:21>>
Action:  Tim Wernicke to Dan Zwick, Assigned:   to Dan Zwick, Priority:  to Stop Rel.
<<END>>