Review PR 247487 F9 on TP FCF and delete tertiary datum, then OK ==> a

huangyhg

F9 on TP FCF and delete tertiary datum, then OK ==> axis nominals are now wrong
<< Don Turcotte  --  04/03/07  10:10:45>>
If you F9 on a TP FCF and delete the teritary datum, then press OK the axis nominals are updated incorrectly so the TP value reported is incorrect.  Also if you change axis nominals when Output alignment=Current, then select Output alignment=Datum reference, the changes are lost.  You must first tab to Feature control frame tab and come back to output tab to get changes to stick.
Steps to reproduce:
Load the program in PR# 247444.
Unmark all, then mark LOC1
Display report in table format.
F9 LOC1 and remove tertiary datum, then OK
Repaint report.
Results:
Report results are wrong.
If you F9 on LOC1 again and look at output tab dimension nominals with Output alignment=datum reference frame, you will see the X nominal is not 0 as it should be.  
Expected Results:
Axis nominals should update with new datum reference frame alignment when you delete a datum in the tp.  Also, when editing the axis nominals, then switch output alignment, then changes should be reflected in the new output alignment.
<<END>>

huangyhg

<< Don Turcotte  --  04/03/07  10:28:52>>
Fixed in V42 beta and V43B.

Files inserted to server
------------------------
V42\MENU\FEATCTRLFRMDLG.CPP
V42\MENU\FEATCTRLFRMOUTPUTDLG.CPP

V43B\MENU\FEATCTRLFRMDLG.CPP
V43B\MENU\FEATCTRLFRMOUTPUTDLG.CPP
<<END>>