PR 242158 dimension colour bar question

huangyhg

dimension colour bar question
<< Jon Kimber  --  07/28/06  09:38:15>>
We have the following problem with version 3.7MR3 tolerancing (please see the attached report): if I have the Y negative BUT the T `in tolerance` I still get the RED colour of my dimension. (red is defined as out of tolerance negative).
Is it possible to display the colour taking into consideration only T? How?
Please see attached .gif file.

<<END>>


<< Neil Kay  --  02/25/09  12:52:34>>
I apologize for taking so long to answer - please reopen if you still need an answer.
<<END>>
<< Changes made by Neil Kay -- 02/25/09  12:52:36>>
Status:  MOREINFO to CLOSED
<<END>>
<< System Administrator  --  2008/10/23  17:35:30>>
PLEASE VERIFY THAT THIS IS AN ISSUE IN PC-DMIS 4.4 AUDIT VERSION.  IF SO, PLEASE RESET THE STATUS TO OPEN.  OTHERWISE PLEASE CLOSE.
<<END>>
<< Changes made by System Administrator  --  2008/10/23  17:35:30>>
Action:  Yanhua Huang to Jon Kimber, Status:  OPEN to MOREINFO
<<END>>
<< Changes made by Neil Kay -- 08/29/08  09:55:13>>
Action:  Woody Anderson to Yanhua Huang, Assigned:  Woody Anderson to Yanhua Huang
<<END>>
<< Changes made by Tim Wernicke -- 07/28/06  10:58:59>>
Action:  Tim Wernicke to Woody Anderson, Assigned:   to Woody Anderson, Priority:  to Medium
<<END>>