when to use slip critical connection for framed beam connect
i have a question as i'm reading through the asd 9 steel manual. when/why would you use a slip critical connection in a framed beam connection as opposed to a bearing simple shear connection? i'm assuming the only applicable case would be high seismic regions. do you typically specify short slotted holes for simple bearing connections to give some tolerance for fit up?
see the following link:
IP卡
狗仔卡
发表于 2009-9-16 20:51:01
提升卡
置顶卡
沉默卡
喧嚣卡
变色卡
显身卡