Is there a way to select (by automation) printing of all dimensions or out of

huangyhg

Is there a way to select (by automation) printing of all dimensions or out of tol only?
Has anyone answered this one?



From: ISAKSSON Anders [email="[mailto:Anders.Isaksson@hexagonmetrology.com]"][mailto:Anders.Isaksson@hexagonmetrology.com][/email]
Sent: 06 August 2010 13:55
To: Questions
Subject: Is there a way to select (by automation) printing of all dimensions or out of tol only?



In one of our automation projects, we have the need to select the report type by automation - either report all dimensions, or report out of tol. only.



Is this possible? If so, how? If not, any ideas how to solve the problem?

huangyhg

I did forward this question to our group members last Saturday.  Just a reminder, does anyone know whether this can be done?

Thanks,  
Andy Roberts        Andy.Roberts@HexagonMetrology.com
pc●dmis Dimensional Reporting
Office:    +1.435.884.0474
http://www.wilcoxassoc.com
http://www.pc-dmis-ems.com
________________________________________
From: Neil Kay
Sent: Tuesday, August 10, 2010 3:35 AM
To: ISAKSSON Anders; Questions
Cc: Alberto Piolatto; PC-DMIS Dimensional Reporting Group
Subject: RE: Is there a way to select (by automation) printing of all dimensions or out of tol only?

Has anyone answered this one?

huangyhg

Andy,

I think this can be done but have not had time yet to try it. I will try to get to this today.

Joe

huangyhg

Yes, this can be done.  

Jay Hall wrote an application that does this for Raytheon.

Jay can you assist here?

Best Regards,
Mike Wilson       Mike.Wilson@HexagonMetrology.com

huangyhg

Hi,

Sorry if someone has already answered this…
If not could you have a look?

Thanks,
Andy Roberts        Andy.Roberts@HexagonMetrology.com