【转帖】change merge results default setting

yang686526

change "merge results" default setting
i'd like to change the default settings for the merge results check box accross the board. i don't want it checked when modeling items to be saved as .stl's. anyone know how to do this?
yea, there's a few default settings i'd like to change, just haven't found where they might be at..
sw2009 sp3.0
pentium d 840-3.2 ghz
4gb ddr2 667
ati firegl v5600 - driver ver. 8.440.0.0
winxp pro 32bit
an understanding that without any understanding, we would all be misunderstood..
where are these merge results you are on about, where do they appear? i have tried saving a file as an stl file and i do not get promted anything.