|
|
hole call outs
it used to be that when you created a hole in hole wizard as," up to next" that the call out read as thru. now no matter what i do i get the exact depth, that is to say if my block is .750 it reads as a .750 deep hole. whats worse is that i can not edit the value to replace it with thru. has anyone else experienced this?
yes. this is a known issue. fixed in sw 2008 sp4.
-handleman, cswp (the new, easy test) |
|
IP卡
狗仔卡
发表于 2009-4-13 11:46:50
提升卡
置顶卡
沉默卡
喧嚣卡
变色卡
显身卡