SolidWorks enhancement request: "The default unit should be millimet

huangyhg

Problem:  "The default unit should be millimeter in SW modeler same as CATIA modeler."
Reference Number: 180726
Date and Time: 3/19/2007 4:00:00 AM
Problem:  "The default unit should be millimeter in SW modeler same as CATIA modeler."

Solution Ideas: "SW API told me that meter was the default unit, and others (such as mm, inch, etc.) were cosmetic. But CATIA v5 modeler units are always millimeter.

When I convert a big SW model to PC-DIMS (an inspection software), it seems to convert more slowly from SW than from CATIA. If SW modeler uses millimeter, it is more convenient for us because we don’t convert unit for every value."

-------