几何尺寸与公差论坛

 找回密码
 注册
查看: 123151|回复: 1

圆跳动——同轴度 (Runout - vs Concentricity)

[复制链接]
发表于 2007-6-16 19:44:10 | 显示全部楼层 |阅读模式
圆跳动——同轴度 (Runout - vs Concentricity)
http://www.dimcax.com/gdt_web/june-97.htm

圆跳动由圆度和同心度两项公差要求组成,如图A所示,被测特征若要求是圆的且是同心的,优先选用圆跳动。
同轴度仅仅是给出被测特征的中心轴线相对于基准轴线的误差变动范围,如图A、B、C、D所示,被测特征可以是具备对称性的椭圆、正方形、六边形等。
Avoid specifying concentricity. Concentricity requires deriving the median line of a feature. All of the features shown below are concentric. Usually, designs require that a feature be round as well as concentric like example A. A better geometric control is usually circular runout. Circular runout controls circularity (roundness) as well as concentricity.




 楼主| 发表于 2007-6-16 20:51:04 | 显示全部楼层

回复: 圆跳动——同轴度 (Runout - vs Concentricity)

在GPS标准中,同轴度一般用

Coaxiality来表示。

您需要登录后才可以回帖 登录 | 注册

本版积分规则

QQ|Archiver|小黑屋|几何尺寸与公差论坛

GMT+8, 2024-3-29 18:00 , Processed in 0.036613 second(s), 19 queries .

Powered by Discuz! X3.4 Licensed

© 2001-2023 Discuz! Team.

快速回复 返回顶部 返回列表