【转帖】blended radius
 

blended radius
is there a proper method for dimensioning a blended radius? my part has a 3mm radius about the perimeter that blends down to 1mm at the mounting locations. other than putting a leader on the drawing stating "blended radius" is there a better way to do this? 14.5 doesn't seem to cover this. in this situation i'm not too worried because i'll be sending the math model to the shop but i am curious as to the proper way to do this. any thoughts?
bsilk
senior designer
eng-tips forums is member supported.
for our shop and inspectors i would dimension this as:
r3max blended r1min
but this is from company standard not iso...