【转帖】dwf export problem - compressed binary 6.0
 

dwf export problem - compressed binary 6.0
dwf export problem - compressed binary 6.0
hi,
there is 'publish' option in odamfcapp. i choose "binary" mode and then it saves all layouts to one file, dwf 6.0, uncompressed binary. when i change sources to export to dw_compressed_binary, not dw_uncompressed_binary, then the file i get is wrong.
when i open it in autodesk dwf viewer, switching to other pages than first, causes an error message and page is not displayed.
no error message while publishing.
tia
regards,
michal sliwka
attached files
quote:
originally posted by sliwka
i choose "binary" mode and then it saves all layouts to one file, dwf 6.0, uncompressed binary. when i change sources to export to dw_compressed_binary, not dw_uncompressed_binary, then the file i get is wrong.
michal,
dwf6 doesn't support compressed_binary. it supports ascii and uncompressed_binary only. i will add a note about this dwf6 character into dwfexport.h.
misha kuzinets
thanks, is solves my problem
regards,
michal sliwka