【转帖】problem reading dwg file with dwgdirect 2.1.3
 

problem reading dwg file with dwgdirect 2.1.3
problem reading dwg file with dwgdirect 2.1.3
i use msvc 2003 and got problems.
to test i compiled odreadex in debug mode. when it loads the dwg file it crashes in
svcs.readfile(
strdwgfilename, true, false, oda::ksharedenyno);
i tried several other dwg-files with the same result .
any idea what to do?
best regards
tried with msvc 2005
when i recompile odreadex with vc 8 (ms vc2005) the program odreadex won't start. ???
is there any general changes that affects the examples?
laurs
it was 2.3.1
actualyy it was the latest version of dwgdirect c++ 2.3.1 and not 2.1.3
i get several "cant restore acdbvisualstyle from proxy" warnings when opening it in odamfcapp (v2.3.1).
i opened it in dwg trueview and got "an error was found during open. we recommend that you cancel this open and run recover...".
i think there's something wrong with the file.
i've attached a .txt file containing the results of running the "recover" command on this file with acad2008.
i hope this helps.
attached files (18.8 kb, 5 views)

dwgdirect 2.3.1 and vc8
thanks.
i have still a lot of problems with any dwg or dxf file.
how do i compile odamfcapp?
i tried to compile as release with all lib , not dll's
laurs
laurs,
if you open
projectfiles\win32\msvc8\allexamples.sln
and build the "odamfcapp" project, that should build everything.
last edited by pete rimkus; 12th june 2007 at 05:43 amfff">.
also note that vc2005 libraries are built with service pack 1.
sergey slezkin