【转帖】recomputedimblock problem 9dwgdirect1.120
 

recomputedimblock problem (dwgdirect1.12)
recomputedimblock problem (dwgdirect1.12)
hello,
when recomputedimblock is performed on dimension in the attached drawing, the dimension tolerances (deviation) gets wrongly updated; tolerance limit lower value gets another minus (thus it has two minus sign --); and it not the the same as in autocad. for example, in acad the tolerance limit lower value is -2, and after recomputedimblock it is 鈥?. i鈥檓 using dwgdirect1.12 version.
is this recomputedimblock bug?
best regards,
anita
attached files

yes, anita, it definitely is recomputedimblock bug.
thank you for bugreport. bug will be fixed in next release/update.
sincerely yours,
george udov
recomputedimblock problem (dwgdirect1.12)
quote:
originally posted by george udov
yes, anita, it definitely is recomputedimblock bug.
thank you for bugreport. bug will be fixed in next release/update.
thank you for your answer (and sorry for delay in my reply, i haven鈥檛 been in office).
do you know when the next update could be expected?
regards,
anita

i think, in the middle of december, but i'm not sure.
sincerely yours,
george udov
recomputedimblock problem (dwgdirect 1.12)
quote:
originally posted by george udov
i think, in the middle of december, but i'm not sure.
thank you,
anita