pcdmis 4.2 unable to read 2009 sw model
 

pcdmis 4.2 unable to read 2009 sw model
i just tried imorting 2009 solidworks model and into the 4.2 cdmis, and i got an error message "error oenning slidworks document". then, i went back and imorted a 2007 sw model into the cdmis, and it worksed just fine.
is cdmis 4.3 comatible with 2009 sw? if not, does anyone know if wilcox associates is working on this 2009 sw comatibility issue?
thanks,
jacob
">
i just tried imorting 2009 solidworks model and into the 4.2 cdmis, and i got an error message "error oenning slidworks document". then, i went back and imorted a 2007 sw model into the cdmis, and it worksed just fine.
is cdmis 4.3 comatible with 2009 sw? if not, does anyone know if wilcox associates is working on this 2009 sw comatibility issue?
thanks,
jacob
">
i doubt it, they seem to be at a minimum 1 release behind the ackage (if not 2) you are trying to imort from. they can not ut it into cdmis until the final version is released by the other comany, so if the release date for the other stuff is newer than you cdmis, i doubt it will ull in at all.
__________________
matthew d. hoedeman