几何尺寸与公差论坛------致力于产品几何量公差标准GD&T (GDT:ASME)|New GPS(ISO)研究/CAD设计/CAM加工/CMM测量

几何尺寸与公差论坛------致力于产品几何量公差标准GD&T (GDT:ASME)|New GPS(ISO)研究/CAD设计/CAM加工/CMM测量 (http://www.dimcax.com/hust/index.php)
-   产品功能分析 (http://www.dimcax.com/hust/forumdisplay.php?f=10)
-   -   use underlayment to compensate for low pitch (http://www.dimcax.com/hust/showthread.php?t=30075)

huangyhg 2009-09-16 05:50 PM

use underlayment to compensate for low pitch
 
use underlayment to compensate for low pitch???
is it possible to design a house addition with a cedar-shake-roofed that is below the code-prescribed 4/12 roof pitch? i'm needing to get down to a 2.25/12 pitch for a small 16' x 16' section of roof. is using ice-and-water shield or similar products under the entire section a viable alternative? i'm planning on specifying cedar breather so that the shakes are not right down on the roof deck.
thanks.
check out our whitepaper library.
check w/ the mfg. if you go below their pitch or the code recommendations - you own the roof.
the state building code probably has a specific requirement for anything under 4/12. there are products designed for this.
good luck,
dermott


所有的时间均为北京时间。 现在的时间是 04:38 PM.