【转帖】ug nx user new to sw - help with expressions please
 

ug nx user new to sw - help with expressions please
hi,
i'm an experienced nx user just starting out with sw. i'm used to re-naming parameters in nx and then using them in expressions such as "length = width/2". can i do something similar to this in sw please?
cheers
check out our whitepaper library.
yes, you may.
read this:
thanks for your help. i'll give that a go.
cheers.
rattler,
welcome to the solidworks forum. the folks here are very helpful, and are very detailed in answering your questions. good luck with the solidworks (aka sw) software. i'm sure you'll enjoy it. there are a lot of aches and pains with sw, just like any other cad software's, like ug nx.
best,
colin fitzpatrick (aka macduff)
mechanical designer
solidworks 2008 sp 4.0
dell 490 xp pro sp 2
xeon cpu 3.00 ghz 3.00 gb of ram
nvida quadro fx 3450 512 mb
3d connexion-spaceexplorer