几何尺寸与公差论坛------致力于产品几何量公差标准GD&T (GDT:ASME)|New GPS(ISO)研究/CAD设计/CAM加工/CMM测量 - 查看单个帖子

helo to decide tolerance
hi all,
i need a little help to determine a tolerance.
i have to design a bracket to fit to a vehicle using two pins. the two holes on the vehicle are at 1000+/-5mm centres. the holes are each 50+/-1mm diameter.
if i make the holes in my bracket the same diameter, what tolerance should i use on the holes centres to ensure the bracket always fits? it is not possible to use slots or adjust the centre distance on site. if i use 1000+/-5mm then their could be a nominal 10mm error.
thanks
check out our whitepaper library.
hi max44
what size are your pins and what tolerance, not sure that with such a wide tolerance of +/- 5mm you can get what you want.
desertfox
hi desertfox,
pin dimensions not yet determined but need to be a nice running fit. i also think that i cannot get a perfect solution but thought i would see if i can get some 'best practise' replies.
thanks
hi max44
not sure how your going to get a nice running fit with +/- 1mm on hole diameters.
to get a useful answer we need all the information (if a useful answer is possible in your case.
with the tolerances your quoting the pins would have to be a large clearence fit at present.
desertfox
the spreadsheet in my 4 sep 08 3:26 post on

2009-09-05, 11:06 AM	#1
huangyhg 超级版主注册日期: 04-03 帖子: 18592 精华: 36 现金: 249466 标准币资产: 1080358888 标准币	helo to decide tolerance helo to decide tolerance hi all, i need a little help to determine a tolerance. i have to design a bracket to fit to a vehicle using two pins. the two holes on the vehicle are at 1000+/-5mm centres. the holes are each 50+/-1mm diameter. if i make the holes in my bracket the same diameter, what tolerance should i use on the holes centres to ensure the bracket always fits? it is not possible to use slots or adjust the centre distance on site. if i use 1000+/-5mm then their could be a nominal 10mm error. thanks check out our whitepaper library. hi max44 what size are your pins and what tolerance, not sure that with such a wide tolerance of +/- 5mm you can get what you want. desertfox hi desertfox, pin dimensions not yet determined but need to be a nice running fit. i also think that i cannot get a perfect solution but thought i would see if i can get some 'best practise' replies. thanks hi max44 not sure how your going to get a nice running fit with +/- 1mm on hole diameters. to get a useful answer we need all the information (if a useful answer is possible in your case. with the tolerances your quoting the pins would have to be a large clearence fit at present. desertfox the spreadsheet in my 4 sep 08 3:26 post on __________________ 借用达朗贝尔的名言：前进吧，你会得到信心! [url="http://www.dimcax.com"]几何尺寸与公差标准[/url]