几何尺寸与公差论坛------致力于产品几何量公差标准GD&T (GDT:ASME)|New GPS(ISO)研究/CAD设计/CAM加工/CMM测量 - 查看单个帖子 - ansi 9standards0 code issues

ansi weldless eyenuts & liftin
hi folks,
have a small problem at work. the mechanics use weldless eyenuts normally used for pipe hangers as rigging eyenuts as well. i told them that they are more than likely made to different standards and their uses should not be mixed up. they only stock weldless eyenuts in their stores right now.
i have seen the eyenuts in a crosby rigging catalog, but they do not quote a standard. i have also seen eyenuts in a pipe hanger supply catalog, again not quoting any standards.
the main physical difference that i know is that the bottom of a rigging eyenut has a larger land machined on the bottom of it.
anyone know where the codes or standards are for these ?
regards
doug
specification for eyebolts for lifting purposes
document number: bs 4278:1984
british standard
30-apr-1984
isbn: 0 580 13801 1
standard specification for carbon steel lifting eyes
document number: astm a489-03
astm international
01-oct-2003
eyebolts for general lifting purposes
document number: iso 3266
international organization for standardization
01-nov-1984
david baird
dugal,
weldless eyenuts are made to mss and federal codes and standards...
i believe the ones you refer to are made to mss-sp-69...
the components have a break strength of a couple of times the rated load (see mss-sp69 for more info)
see page 130 of this link:

2009-09-05, 06:03 PM	#1
huangyhg 超级版主注册日期: 04-03 帖子: 18592 精华: 36 现金: 249466 标准币资产: 1080358888 标准币	ansi 9standards0 code issues - weldless eyenuts liftin ansi weldless eyenuts & liftin hi folks, have a small problem at work. the mechanics use weldless eyenuts normally used for pipe hangers as rigging eyenuts as well. i told them that they are more than likely made to different standards and their uses should not be mixed up. they only stock weldless eyenuts in their stores right now. i have seen the eyenuts in a crosby rigging catalog, but they do not quote a standard. i have also seen eyenuts in a pipe hanger supply catalog, again not quoting any standards. the main physical difference that i know is that the bottom of a rigging eyenut has a larger land machined on the bottom of it. anyone know where the codes or standards are for these ? regards doug specification for eyebolts for lifting purposes document number: bs 4278:1984 british standard 30-apr-1984 isbn: 0 580 13801 1 standard specification for carbon steel lifting eyes document number: astm a489-03 astm international 01-oct-2003 eyebolts for general lifting purposes document number: iso 3266 international organization for standardization 01-nov-1984 david baird dugal, weldless eyenuts are made to mss and federal codes and standards... i believe the ones you refer to are made to mss-sp-69... the components have a break strength of a couple of times the rated load (see mss-sp69 for more info) see page 130 of this link: __________________ 借用达朗贝尔的名言：前进吧，你会得到信心! [url="http://www.dimcax.com"]几何尺寸与公差标准[/url]