几何尺寸与公差论坛------致力于产品几何量公差标准GD&T (GDT:ASME)|New GPS(ISO)研究/CAD设计/CAM加工/CMM测量 - 查看单个帖子

uns thread information
hi,
trying to find some thread data (i.e. maj. dia, pitch dia. etc...etc..) for the following thread:
1.563 - 18 uns - 3a
the machinist's handbook outlines some unified thread types but does not seem to include this uns thread! unless i am looking in the wrong place! any help would be appreciated
thanks
check out our whitepaper library.
johni357,
my copy of machinery's handbook lists uns threads as "selected combinations" of diameter and pitch. uns threads are listed in table 14 labeled "standard series and selected combinations". the catch is that the 1.563-18 thread is listed as unef (extra fine) not uns. the good news is the table gives you all the data you need for the 1-9/16-18 thread.
timelord
you could search in google, or this forum:
timelordfff">, i think you meant table 4.
"art without engineering is dreaming; engineering without art is calculating."
mm,
my bad, table 4 is correct. in the section called screw thread systems.
timelord
in uns the s means special, so by definition it is not a standard size and is unlikely to be in a pre-calculated table. this means you should calculate it from scratch using the definitions in asme b1.1 or equivalent.
from what timelord says your example may not actually be a special but a standard unef.

2009-09-06, 09:37 AM	#1
huangyhg 超级版主注册日期: 04-03 帖子: 18592 精华: 36 现金: 249466 标准币资产: 1080358888 标准币	uns thread information uns thread information hi, trying to find some thread data (i.e. maj. dia, pitch dia. etc...etc..) for the following thread: 1.563 - 18 uns - 3a the machinist's handbook outlines some unified thread types but does not seem to include this uns thread! unless i am looking in the wrong place! any help would be appreciated thanks check out our whitepaper library. johni357, my copy of machinery's handbook lists uns threads as "selected combinations" of diameter and pitch. uns threads are listed in table 14 labeled "standard series and selected combinations". the catch is that the 1.563-18 thread is listed as unef (extra fine) not uns. the good news is the table gives you all the data you need for the 1-9/16-18 thread. timelord you could search in google, or this forum: timelordfff">, i think you meant table 4. "art without engineering is dreaming; engineering without art is calculating." mm, my bad, table 4 is correct. in the section called screw thread systems. timelord in uns the s means special, so by definition it is not a standard size and is unlikely to be in a pre-calculated table. this means you should calculate it from scratch using the definitions in asme b1.1 or equivalent. from what timelord says your example may not actually be a special but a standard unef. __________________ 借用达朗贝尔的名言：前进吧，你会得到信心! [url="http://www.dimcax.com"]几何尺寸与公差标准[/url]