几何尺寸与公差论坛------致力于产品几何量公差标准GD&T (GDT:ASME)|New GPS(ISO)研究/CAD设计/CAM加工/CMM测量 - 查看单个帖子 - aashto article 10.24.6.1

aashto article 10.24.6.1 - fastener sealing
aashto article 10.24.6.1 gives guidance on fastener spacing for "sealing against the penetration of moisture in joints". ohio dot's concrete deck haunch starts at the bottom of the top flange and proceeds to the deck at an angle. this means that the outside (above the top flange) top flange splice plate is embedded in concrete. does anyone have any information as to whether, in this case, we must still adhere to aashto article 10.24.6.1? does anyone know of any discussion or commentary on the subject? odot does not have any discussion in the bridge design manual.

__________________
借用达朗贝尔的名言：前进吧，你会得到信心!
[url="http://www.dimcax.com"]几何尺寸与公差标准[/url]

2009-09-07, 09:19 AM	#1
huangyhg 超级版主注册日期: 04-03 帖子: 18592 精华: 36 现金: 249466 标准币资产: 1080358888 标准币	aashto article 10.24.6.1 - fastener sealing aashto article 10.24.6.1 - fastener sealing aashto article 10.24.6.1 gives guidance on fastener spacing for "sealing against the penetration of moisture in joints". ohio dot's concrete deck haunch starts at the bottom of the top flange and proceeds to the deck at an angle. this means that the outside (above the top flange) top flange splice plate is embedded in concrete. does anyone have any information as to whether, in this case, we must still adhere to aashto article 10.24.6.1? does anyone know of any discussion or commentary on the subject? odot does not have any discussion in the bridge design manual. __________________ 借用达朗贝尔的名言：前进吧，你会得到信心! [url="http://www.dimcax.com"]几何尺寸与公差标准[/url]