几何尺寸与公差论坛------致力于产品几何量公差标准GD&T (GDT:ASME)|New GPS(ISO)研究/CAD设计/CAM加工/CMM测量 - 查看单个帖子

allowable shear stress
i am using an allowable shear stress of .85*2*sqrt(fc) to get allowable shear stress in psi. i noticed that factor changed in the new aci to .75, but they do allow it in appendix c if you use there load factors. i assume it is ok to use .85 for now. does anyone have any comments on this?
t.

just be consistent. you can use the higher resistance factors if you use the historically higher aci load factors (e.g. 1.4d+1.7l). but you must use the lower resistance factors if you use the lower asce 7 load factors (e.g. 1.2d+1.6l).
i would second what taro says.

__________________
借用达朗贝尔的名言：前进吧，你会得到信心!
[url="http://www.dimcax.com"]几何尺寸与公差标准[/url]

2009-09-07, 11:05 AM	#1
huangyhg 超级版主注册日期: 04-03 帖子: 18592 精华: 36 现金: 249466 标准币资产: 1080358888 标准币	allowable shear stress allowable shear stress i am using an allowable shear stress of .852sqrt(fc) to get allowable shear stress in psi. i noticed that factor changed in the new aci to .75, but they do allow it in appendix c if you use there load factors. i assume it is ok to use .85 for now. does anyone have any comments on this? t. just be consistent. you can use the higher resistance factors if you use the historically higher aci load factors (e.g. 1.4d+1.7l). but you must use the lower resistance factors if you use the lower asce 7 load factors (e.g. 1.2d+1.6l). i would second what taro says. __________________ 借用达朗贝尔的名言：前进吧，你会得到信心! [url="http://www.dimcax.com"]几何尺寸与公差标准[/url]