几何尺寸与公差论坛------致力于产品几何量公差标准GD&T (GDT:ASME)|New GPS(ISO)研究/CAD设计/CAM加工/CMM测量 - 查看单个帖子

bending stress in circular weld
welding of a circular pipe to a flat plate where the pipe is in pure bending. i've seen the weld stress calculated as
m/sw
m=moment
sw=circular property of the weld
is this the section properties of that of a circular ring, with the effective throat being the thickness of the ring?
check out our whitepaper library.
treat it as a section with wall thickness =1.
this gives you weld load per in (or mm)
or look in blodgett's design of welded structures. it will give you sx in in^2 (which is what csd is talking about by using the thickness of 1). then when you use m/sw, you will get k/in to compare to your weld.
hi apetr26542
stress = m/(zw * w)
w = leg size of weld
m= moment
zw= section modulus of weld treated
as a line= 3.142*d^2/(4)
where d = tube dia
regards
desertfox

2009-09-07, 03:31 PM	#1
huangyhg 超级版主注册日期: 04-03 帖子: 18592 精华: 36 现金: 249466 标准币资产: 1080358888 标准币	bending stress in circular weld bending stress in circular weld welding of a circular pipe to a flat plate where the pipe is in pure bending. i've seen the weld stress calculated as m/sw m=moment sw=circular property of the weld is this the section properties of that of a circular ring, with the effective throat being the thickness of the ring? check out our whitepaper library. treat it as a section with wall thickness =1. this gives you weld load per in (or mm) or look in blodgett's design of welded structures. it will give you sx in in^2 (which is what csd is talking about by using the thickness of 1). then when you use m/sw, you will get k/in to compare to your weld. hi apetr26542 stress = m/(zw * w) w = leg size of weld m= moment zw= section modulus of weld treated as a line= 3.142*d^2/(4) where d = tube dia regards desertfox __________________ 借用达朗贝尔的名言：前进吧，你会得到信心! [url="http://www.dimcax.com"]几何尺寸与公差标准[/url]